NEAT CUT-20 It is a light coloured product containing chlorinated EP additive. This product is recommended for use in Automobile, Bearing and Watch industries for Honing, Lapping and Super finishing operations of ferrous and non-ferrous metals.
NEAT CUT-21
This is a low viscosity, light coloured products containing chlorinated EP and oiliness additives. It is suitable for machining operation on mild steels, carbon steels, nickel steels and manganese steels and its use may be extended to copper, aluminium and their alloys if required. NEAT CUT-21 meets IS: 3065-1985 Type I, Grade II (Re-affirmed in 1990) requirements.
NOT IMAGE AVAILABLE
NEAT CUT-23
This product contains additives, which impart high oiliness as well as EP Properties. It affords good cooling, chip flushing and penetration .It is suitable for high speed automatic machine tools and may also be used as a general-purpose machine tool lubricant. NEAT CUT-23 meets IS: 3065-1985 Type II, Grade II (Re-affirmed in 1990) and also meets OilZX-6 requirements.
NEAT CUT-25
This contains a higher oiliness additive than NEAT CUT-23 and also contains inactive sulfur. It finds application on multispindle lathes where a number of operations like turning, honing, chamfering etc are performed.
NEAT CUT-26
This contains both chlorine as well as inactive sulfur and is more potent then the NEAT CUT grades listed above. It also contains oiliness additive and is suitable for most operations on medium-machinability metals and even for severe operations on some of the free cutting steels and alloys.
NEAT CUT-27
This is a blend of low viscosity Mineral oils and oiliness additives and contains chlorine and inactive sulfur. By virtue of its low viscosity, if has excellent cooling and chip flushing ability. It finds use in gun drilling operations and is found to be particularly useful on pull-honing machines.
TYPICAL CHARACTERISTICS
S.No.
PROPERTIES
NEAT CUT
20
21
23
25
26
27
1.
Viscosity, cST @ 40 °C
4.0 - 6.5 (@100°C)
20-30
27-42
31 -42
23-36
8- 17
2.
Flash Point, COC, °C,Min.
110
160
160
160
160
145
3.
Saponification number, Mg KOH/gm, Min
-
9 - 10.5
9.0
-
-
-
CONTAINS:
1.
Inactive sulfur
X
X
P
P
P
P
2.
Active sulfur
X
X
X
X
X
x
3.
Chlorine
P
P
X
X
P
P
These are typical figures and do not constitute a specification
