NEAT CUT-54 This product contains sulfur plus additives. It is a low viscosity grade specially developed for deep hole drilling and precision grinding of all kinds of steel. It is also used in other machining operations where low viscosity is required and is recommended for thread rolling. It meets the requirements of IS: 3065 Type III Specs.
NEAT CUT-55
This is a medium viscosity dark brown oil containing active sulfur, chlorine and oiliness additives. It is suitable for all machining operations on high tensile steel and for less severe operations on stainless and heat resistant alloys. It is also recommended for gear hobbing, thread-cutting machines etc.
NOT IMAGE AVAILABLE
NEAT CUT-56 This is a similar in viscosity and appearance to NEAT CUT-55 but has a more potent additive package. It has similar application but gives improved finished and tool life particularly in threading, turning, broaching, trepanning and thread grinding operations.
NEAT CUT-58
It is a dark coloured medium viscosity product containing a high dosage of sulfur and is used where colour of oil is unimportant. It is recommended for heavy duty threading, tapping and broaching.
TYPICAL CHARACTERISTICS
S.No.
PROPERTIES
NEAT CUT
54
55
56
58
1.
Viscosity, cST @ 40°C
12.7-23.2
32-42
32-45
29-38
2.
Flash Point, COC,°C, Min.
135
160
160
160
3.
Saponifiable Matter % by wt.
5
1.5
1.5
-
Contains
4.
Inactive sulfur
P
X
P
X
5.
Active sulfur
P
P
P
P
6.
Chlorine
X
P
P
X
These are typical figures and do not constitute a specification
NEAT CUT-225
This is a new generation metal working product blended with low viscosity refined mineral oil and superior additive to provide a better film forming capability. The oil also contains chlorinated Extreme Pressure additive to provide adequate EP properties.
• Excellent Lubricity.
• Greater penetration
• Effective cooling.
• Chip flushing ability.
All above factors result in better surface finish and prolonged tool life.
The oil is recommended for all machining operations involving high speeds and low to moderate severity. It is also recommended for honing and other super finishing operations.
TYPICAL CHARACTERISTICS
S.No.
PROPERTIES
NEAT CUT-225
1.
Appearance
Red
2.
Viscosity, cST @ 40°C
2.0-7.5
3.
Flash Point, COC,°C, Min.
90
4.
EP Value (4 Ball Test) OK Load - Kg., Min.
250
5.
Weld Load -Kg., Min
270
6.
Copper Strip Corrosion, 3hr. @ 1OO°C, Max.
1
These are typical figures and do not constitute a specification
